Digital Clamp Meter, 9mm jaw opening capability - CA-60

(No reviews yet) Write a Review
700.00 Grams
Minimum Purchase:
1 unit
  • Digital Clamp Meter, 9mm jaw opening capability - CA-60
  • Digital Clamp Meter, 9mm jaw opening capability - CA-60


Tecpel AC/ DC mA Current Clamp transducer - CA-60

High conversion factor, lightweight design, high frequency response at 20 kHz - Accurate and Reliable

This Tecpel AC/DC current clamp in an accessory which will allow your multimeter to measure electrical current up to 60Amperes DC/AC, with a frequency response up to 400MHz. When measuring current with this clamp, there is no need to break a circuit or to affect the isolation.

Current Clamp transducer CA-60 from Tecpel comes with the following properties:

  • Two Hall effect sensors for use with any multimeter with 200mV or/and 2V ranges for direct readout input impedance of least 1M ohm.
  • High conversion factor for low DC and AC mA measurement.
  • With the small jaw size, it can fit into tight space in circuit panel or wire bundle to take the reading
  • The high frequency response at 20 kHz is useful for waveform monitoring on an oscilloscope.
  • Zero adjustment is made easy by just pushing the ZERO button.
  • It is best for locating small signal, industrial control, battery leakage, and automotive usage

Specifications for Current Clamp transducer - CA-60 Tecpel

  • 0 ~ 60 Amp DC or AC current
  • 9mm 3/8 " Conductor jaw opening capability, fits tight space
  • Transformer ratio: 10:1, 100:1
  • 1 mV/10mA or 1 mV/100mA conversion
  • Frequency response to 20 kHz


  • DC A : +/- 1.5% ACA : +/- 2% (40Hz ~ 2K Hz)
  • AC A: +/- 4% ( 2K ~ 10KHz)
  • AC A: +/- 6% ( 10K ~ 20K Hz)


  • 1mV/ 10mA, 1mV/ 100mA


  • 7.7" x 2.8" x 1.3"


  • Designed to meet IEC 100-1 , IEC 1010-2-032 CE


  • CE


Brand Information

Tecpel Co. Ltd. has over 20 years of experience in the Test and Measurement market. They have set up over 50 country distributors worldwide. Some of their products have been branded by famous leaders in the market. About 60% of their customers are repeat customers. Tecpel imports products from Japan and carries out quality checks. Their products are exported to Europe mainly. If customers find a fault with the product, they will replace it with a new product within 2-3 days.

They are regarded as one of the leading Taiwanese manufactures of high quality test and measurements. Their product lines include power supplies, oscilloscopes, electronics & electrical meters and testers. Tecpel’s quality products have been accepted by some well-known international customers. The confidence they have in their products is reflected in their one-year warranty and by their flat-rate service policy through 3-5 years.

View AllClose

Warranty Information

One-Year Warranty
View AllClose

Additional Information

AC/DC Current Range:
0 ~ 60 Amp.
Conductor jaw opening capability:
9mm 3/8 "".
Transformer ratio:
10:1, 100:1.
Frequency response to 20 kHz:
1 mV/10mA or 1 mV/100mA conversion.
• DC A: +/- 1.5% ACA: +/- 2% (40Hz ~ 2K Hz). • AC A: +/- 4% (2K ~ 10 KHz). • AC A: +/- 6% (10K ~ 20 KHz).
1mV/ 10mA, 1mV/ 100mA.
7.7"" x 2.8"" x 1.3"".
Designed to meet IEC 100-1, IEC 1010-2-032 CE.
CA-06 Adapter (Option):
BNC- Female 4mm Banana post adapter for receiving Signal output from CA-60 and able to be monitored by oscilloscope.
View AllClose