"Fiber Optic Amplifier Fiber Amplifier ( BR1 Series)
Type: Din Rail
Wire Type: 3 wires
Output Type: PNP/NPN - L-on/D-on
Frequency: 1 Khz
Connection: 2 mtrs. cable
Brand / Origin: Riko/Taiwan"
◆ Fiber amplifier mounting/detaching operation：
(1)To mount each amplifier to the attached mounting bracket or DIN rail in sequence.
◆ Fiber cables fixing operation：
1. Insert the fiber cables
Open the protective hood and tilt the fiber lock lever to release the lock condition. Referring to the side seal of insertion position, fully insert the fiber cables into the mounting holes until the limit.
Pull the fiber lock lever back to lock the cables.
(2)To connect two amplifiers close together by sliding the amplifier bodies.
2. Pull out the fiber cables
Open the protective hood and tilt the fiber lock lever to release the lock condition. Pull the fiber cables straight out from the mounting holes.
To detach the amplifiers in sequence by sliding the amplifier bodies. Don't detach two amplifiers at a time.
Notes:To protect the fiber cables from incorrect operation, be sure to tilt the fiber lock lever to release the lock condition before pulling out the fiber cables.
Notes:Be sure to switch off the power supply when mounting or detaching the amplifier.
Customers Also Viewed