- DAT-1110 Temperature Transmitter
The DAT1135 Temperature converter is a Thermocouple Head Mounted Temperature converter. The output is 0-10 volts with the minimum span being 1 V, so all the standard outputs are possible, 0-10V, 1-5V and 2-10V. The input accepts Thermocouples, RTD's, mV's, Potentiometers and resistance inputs. The DAT1135 is programmable by a PC using the Prodat and the DATASOFT software. The sensor, range, zero and linearization are programmable. The input is measured, linearized and converted to the industrial standard. The RTD and resistance input have the added feature of selecting 3 or 4 wire for higher accuracy. There is a burn out failure alarm that can be programmed to drive the output signal High and Low.
The input on the DAT1135 has a high range of tolerance and the DAT1135 can accept any voltage between 10 V and 32 V.
The thermocouple selection type is J, K, S, R, B, E, T and N.
The RTD sensor is selectable for Pt100, Pt1000, Ni100 or Ni1000.
The resistance input is selectable from 0-200, 0-500, 0-2000 Ohms.
The mV input is selectable from -100mV to 700mV with a minimum span of 2 mV.
The Potentiometer can accept resistance in the range of 0-200 Ohms, 200-500 Ohms and 0.5 to 2 kohms.
The RTD and resistance can be 2 wire or use compensation wire to improve accuracy i.e. 3 or 4 wire.
Thermocouple J, K, S, R, B, E, T, N. RTD Pt100, Pt1000, Ni100, Ni1000.
Resistance 0-200 0-500 0-2kohms
mV -100 to 700 mV
Potentiometer up to 2 k ohms
Power Supply Voltage 10-32Vdc
Reverse polarity protection 60Vdc
For Industrial environments
Immunity EN 61000-6-2
Emission EN 6100-6-4
Dimensions W X H
1 3/4" x 1"
43 x 24 mm
Weight 1 1/2 oz 50 g
Operating Temperature -4°F +158°F -20°C +70°C
Storage Temperature -40°F +185°F-40°C +85°C
Humidity (non condensing) 0-90%
Customers Also Viewed